Introduction

• This PCI Host Adapter can upgrade your desktop computer to have dual Ultra ATA-133 Channels for 4 connections of ATA/ATAPI devices. It can support Low profile PCI and regular size PCI both. The board provides a 32bit, 33/66 MHz PCI interface on the host side and dual, fully compliant Ultra ATA-133 channels on the device side to access Ultra ATA storage media such as hard disk drive, floppy disk drive, CD-ROM, CD-RW, DVD-ROM.

Features

• Provides 2 Brackets to Support Low profile PCI and Regular size PCI in one card
• 48 bits LBA can Break Capacity-Limit to Support HDD larger than 137GB
• Supports two independent ATA channels
• Supports ATA 133
• Supports full speed burst transfers on the ATA bus
• Supports software-controlled ATA bus tri-state
• Supports device specific timing registers
• Supports device read-ahead and write-ahead capability under Virtual DMA
• Features one 256-byte FIFO (32-bit x 64 deep) per IDE channel for host reads and writes
• Features ATA to PCI interrupt masking
• Features command buffering from the PCI to ATA
• Features Virtual DMA: Bus master transfer on the PCI bus and PIO transfer on the ATA bus
• Features Watch Dog Timer for fault resiliency
• Compliant with PCI Specification, revision 2.2
• Integrated PCI DMA engines
• 32 bit, 33MHz fully compliant PCI host interface
• Completely with drivers for Windows 98, Windows Millennium, Windows NT 4.0, Windows 2000 and XP
• Supports 64bit / 32bit Windows Vista

System Requirements

• IBM compatible PC
• Available PCI Slot

Package Contents

• CD Driver
• User Manual
• ATA 133 card

Supported O.S.

• Completely with drivers for Windows 98, Windows Millennium, Windows NT 4.0, Windows 2000 and XP
• Supports 64bit / 32bit Windows Vista

Specification

• Not Applicable